To test if QoS is working on your VyOS router, you can use several approaches from clients 192.168.51.100 (LAN) or 192.168.100.11 (DMZ): 1. View QoS Statistics on VyOS
VyOS
VyOS
How to add eth3 to the LAN bridge br0
To add eth3 to the LAN bridge br0, use this command: This will add eth3 as a bridge member alongside eth0, making both interfaces part of the 192.168.51.0/24
VyOS
How to run a script every 10 minutes on VyOS
To run a script every 10 minutes on VyOS, you should use the VyOS task scheduler. Here’s how to configure it: Using VyOS Task Scheduler Verify the Configuration
Linux VyOS
How to run iperf3 as a server accessible from the WAN on your VyOS router
To run iperf3 as a server accessible from the WAN on your VyOS router, you’ll need to: 1. Install iperf3 (if not already installed) 2. Add a firewall
Linux VyOS
How to check all configuration on VyOS
To check all configuration on VyOS 2025 rolling release, you can use these commands: In Operational Mode View the entire running configuration: View configuration as set commands: This
Linux VyOS
Complete VyOS Configuration for Your Setup
Complete VyOS Configuration for Your Setup Here’s the entire configuration with all corrections applied: Initial Installation Complete Configuration (Copy/Paste Friendly) Verification Commands Quick Backup Important Notes Test Your